89424G
1.INSTALL INTAKE AIR TEMPERATURE SENSOR (for Intake Manifold Side)
Install a new gasket to the intake air temperature sensor.
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, install the intake air temperature sensor.
Do not damage the intake air temperature sensor.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 17.2 N*m (175 kgf*cm, 13 ft.*lbf)
Connect the wire harness bracket with the bolt.
Connect the 2 clamps.
Connect the intake air temperature sensor connector.
89424D
2.INSTALL INTAKE AIR TEMPERATURE SENSOR (for Intercooler Side)
Install a new gasket to the intake air temperature sensor.
Using a deep socket wrench, install the intake air temperature sensor.
Connect the intake air temperature sensor connector.
44379A
3.INSTALL NO. 2 OIL RESERVOIR BRACKET
44360
4.CONNECT VANE PUMP OIL RESERVOIR ASSEMBLY
53712C
5.INSTALL FRONT FENDER APRON LH
58701A
6.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
33820B
7.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
58841A
8.INSTALL SHIFTING HOLE COVER (for Automatic Transmission)
58123A
9.INSTALL SHIFT AND SELECT LEVER SUPPORT WITH BOOTS (for Manual Transmission)
58420
10.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58734B
11.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP
58410
12.INSTALL ENGINE SERVICE HOLE COVER
58521D
13.INSTALL ENGINE SERVICE HOLE COVER MAT