Home › Engine / Hybrid System › N04C-VQ (COOLING) › WATER PUMP › from 2019.08
RM2850E _51 Engine / Hybrid System _073147 N04C-VQ COOLING _0355929 WATER PUMP G

N04C-VQ COOLING  WATER PUMP  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

HINT:
·

The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the bottom of the engine water pump assembly. Engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces.

·

Before performing this inspection, check that there is no engine coolant leaking from any parts other than the engine water pump assembly. If there are leaks, inspect those areas.

·

Perform this inspection when the engine is cold.



a.

Visually check the engine water pump assembly.

i.

Check that engine coolant is not dripping from the engine water pump assembly.

HINT:

If engine coolant is dripping, replace the engine water pump assembly.




Hide 16371 2.REMOVE FAN PULLEY

Hide 16100 3.INSPECT ENGINE WATER PUMP ASSEMBLY

a.
A448602

Turn the pulley and check that the engine water pump bearing moves smoothly and quietly.

If necessary, replace the engine water pump assembly.


Hide 16371 4.INSTALL FAN PULLEY