Home › Engine / Hybrid System › N04C-VL (LUBRICATION) › OIL PRESSURE SWITCH › from 2019.08
RM2850E _51 Engine / Hybrid System _073165 N04C-VL LUBRICATION _0356028 OIL PRESSURE SWITCH G

N04C-VL LUBRICATION  OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Remove the front fender apron RH.

Click hereEngine / Hybrid System>N04C-VL (INTAKE)>TURBOCHARGER>REMOVAL


b.
A448332

Disconnect the engine oil pressure switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Body ground Idling 10 kΩ or higher
Engine stopped Below 1 Ω


HINT:

If the value is not as specified, replace the engine oil pressure switch assembly.



d.

Connect the engine oil pressure switch assembly connector.


e.

Install the front fender apron RH.

Click hereEngine / Hybrid System>N04C-VL (INTAKE)>TURBOCHARGER>INSTALLATION