48069
1.INSTALL LOWER SUSPENSION ARM
Install the lower suspension arm to the frame with adjusting cams.
Temporarily install the 2 riuts to the front and rear adjusting cams.
2.CONNECT FRONT SHOCK ABSORBER AND LOWER SUSPENSION ARM
Juck up the lower suspension arm, then connect the shock absorber and lower suspension arm.
Torque the front shock absorber lower set nut.
69 N*m (700 kgf*cm, 51 ft.*lbf)
Torque the lower ball joint.
205 N*m (2,100 kgf*cm, 152 ft.*lbf)
Install a new cotter pin.
3.CONNECT KNUCKLE ARM
w/ Disc brake:
Connect the knuckle arm with the bolt and nut.
220 N*m (2,250 kgf*cm, 163 ft.*lbf)
w/ Drum brake:
Connect the knuckle arm with the 2 bolts and nuts.
185 N*m (1,900 kgf*cm, 137 ft.*lbf)
Install 2 new cotter pins.
4.INSTALL FRONT AXLE HUB
5. STABILIZE SUSPENSION
Install the front wheel and lower the vehicle.
Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL>INSTALLATION
Bounce the vehicle up and down several times to allow the suspension to settle.
6. TORQUE ADJUSTING CAMS
Align the matchmarks and torque the adjusting nut.
215 N*m (2,200 kgf*cm, 158 ft.*lbf)
7.CHECK FRONT WHEEL ALIGNMENT
for 1BZ-FPE:Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT (for 1BZ-FPE)>ADJUSTMENT
for 1HZ:Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT (for 1HZ)>ADJUSTMENT
for 2TR-FE:Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT (for 2TR-FE)>ADJUSTMENT
for N04C Series Engine:Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT (for N04C Series Engine)>ADJUSTMENT