Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
43226
1.INSTALL STEERING KNUCKLE SPACER
Perform this procedure only when replacement of the steering knuckle spacer is necessary.
Using SST and a press, press in a new steering knuckle spacer to the steering knuckle LH.
43212
2.INSTALL STEERING KNUCKLE LH
Using a 27 mm socket wrench, install the front upper suspension arm assembly LH to the steering knuckle LH with the nut.
165 N*m (1683 kgf*cm, 122 ft.*lbf)
Install a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut an additional 30°.
Using a 30 mm socket wrench, install the front lower suspension arm assembly LH to the steering knuckle LH with the nut.
205 N*m (2090 kgf*cm, 151 ft.*lbf)
Install a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut an additional 30°.
48520
3.CONNECT FRONT SHOCK ABSORBER ASSEMBLY LH
Jack up the front lower suspension arm assembly LH with a wooden block between the front lower suspension arm assembly LH.
Connect the front shock absorber assembly LH to the front lower suspension arm assembly LH with the bolt, plate washer, spring washer and nut.
Insert the bolt from the rear of the vehicle.
Tighten the nut.
69 N*m (704 kgf*cm, 51 ft.*lbf)
47704
4.INSTALL FRONT DISC BRAKE DUST COVER SUB-ASSEMBLY LH (for Front Disc Brake)
Install the front disc brake dust cover sub-assembly LH to the steering knuckle LH with the 2 bolts and 2 nuts.
Tighten the bolt A.
110 N*m (1122 kgf*cm, 81 ft.*lbf)
Tighten the nut B.
220 N*m (2243 kgf*cm, 162 ft.*lbf)
5.INSTALL FRONT DRUM BRAKE (for Front Drum Brake)
43520A
6.INSTALL FRONT AXLE HUB SUB-ASSEMBLY
7.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
for 1BZ-FPE:
Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT (for 1BZ-FPE)>ADJUSTMENT
for 2TR-FE:
Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT (for 2TR-FE)>ADJUSTMENT
for N04C Series Engine:
Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT (for N04C Series Engine)>ADJUSTMENT