Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › INTAKE AIR TEMPERATURE SENSOR › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0454124 INTAKE AIR TEMPERATURE SENSOR A

N04C-VJ ENGINE CONTROL  INTAKE AIR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89424G 1.INSTALL INTAKE AIR TEMPERATURE SENSOR

a.

Install a new gasket to the intake air temperature sensor.


b.
A342273C02
1.844,1.615 2.156,1.813 0.313,0.198 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, install the intake air temperature sensor.

Torque:
Specified tightening torque : 19.6 N*m (200 kgf*cm, 14 ft.*lbf)

NOTICE:

Do not damage the intake air temperature sensor.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 180 mm (7.087 in.)): 17.2 N*m (175 kgf*cm, 13 ft.*lbf)




c.

Connect the clamp.


d.

Attach the claw.


e.

Connect the intake air temperature sensor connector.


Hide 44379A 2.INSTALL NO. 2 OIL RESERVOIR BRACKET

Hide 44360 3.CONNECT VANE PUMP OIL RESERVOIR ASSEMBLY

Hide 58701A 4.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 33820B 5.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 58420 7.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58734B 8.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58410 9.INSTALL ENGINE SERVICE HOLE COVER

Hide 58521D 10.INSTALL ENGINE SERVICE HOLE COVER MAT