Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › from 2021.01
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0456368 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column.


for 2 connectors Type:

(Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 2 Connectors Type)>PRECAUTION)


for 3 connectors Type:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 4.REMOVE STEERING WHEEL ASSEMBLY

Hide 5.REMOVE LOWER STEERING COLUMN COVER

Hide 6.REMOVE UPPER STEERING COLUMN COVER

Hide 7.REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

NOTICE:
·

Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.

·

Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.

·

When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel installed.



a.
C364106E01
0.958,2.208 1.094,1.958 1.094,1.958 1.25,1.958 false 1.344,1.885 1.656,2.083 0.313,0.198 10 false *1

Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral with sensor cable sub-assembly.

Text in Illustration
*1 Slider

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



b.

Disconnect each connector from the spiral with sensor cable sub-assembly.


c.
C364105

Detach the 3 claws and remove the spiral with sensor cable sub-assembly.