Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for Drum Type) › from 2021.01
RM2850E _54 Brake _073227 BRAKE (FRONT) _0356449 FRONT BRAKE(for Drum Type) A

BRAKE (FRONT)  FRONT BRAKE(for Drum Type)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:

Assemble the parts in the correct direction, as shown below.


C397375

PROCEDURE

Hide 1. WHEEL CYLINDER ASSEMBLE

a.
C397376

Apply lithium soap base glycol grease to parts, as shown.


b.

Assemble the wheel cylinder.

HINT:

Install in proper direction only.

·

Cup

·

Boot




c.
C397377

Install the adjusting bolt and nut to the wheel cylinder.

There are 2 kinds of adjusting nuts and bolts. Make sure each location has its correct adjusting nuts and bolts.

RH Wheel (R mark)- Right-hand threads

LH Wheel (L mark) - Left- hand threads



d.

Install the adjusting lock spring with the screw.


Hide 2.INSTALL BACKING PLATE TO STEERING KNUCKLE

a.
C397378

Install the backing plate with the nuts, and tighten the nuts.

Torque:

185 N*m (1,900 kgf*cm, 137 ft*lbf)



b.

Install 2 new cotter pins.


Hide 3.INSTALL BLEEDER PLUG

C397379

HINT:
·

Front-wheel cylinder union seats are flat and flare shaped, as shown.

·

Both union seats of front side wheel cylinder are flat.



Hide 4.INSTALL WHEEL CYLINDERS TO BACKING PLATE

a.
C397369

Install the front side wheel cylinder with the adjuster facing downward.


b.

Install the rear side wheel cylinder with the adjuster facing upward.


c.

Tighten the mounting bolts of the wheel cylinders.

Torque:

61 N*m (620 kgf*cm, 45 ft*lbf)



Hide 5.INSTALL BRAKE LINE TO WHEEL CYLINDER

a.
C397368

Install the brake line in place and tighten the nuts by finger, then tighten them with SST.

SST
09751-36011  

Torque:

15 N*m (155 kgf*cm, 11 ft*lbf)



b.
C397367

Install the brake hose on the wheel cylinder with 2 new gaskets.

Torque:

30 N*m (310 kgf*cm, 22 ft*lbf)



Hide 6.INSTALL BRAKE TUBE CLAMP TO BACKING PLATE

Hide 7.INSTALL BRAKE SHOES

a.
C397380

Apply high temperature grease to the brake shoe contact surfaces, as shown.


b.
C397381

Hook the return spring to the brake shoe front inner side.


c.

Install the brake shoes, as shown in the illustration.

HINT:

Install the shoe so that the letters "ANCHOR" on the shoe are directly above the anchor of the body.



d.
C397365

Using SST, install the shoe hold-down springs, cups and pins.


e.
C397382

Using SST, install the other side return spring.


Hide 8.CLEAN LINING AND INNER DRUM WITH SANDPAPER

Hide 9.INSTALL AXLE HUB WITH DRUM

Hide 10. FILL BRAKE RESERVOIR WITH BRAKE FLUID AND BLEED BRAKE SYSTEM

Hide 11. CHECK FLUID LEAKAGE

Hide 12.ADJUST BRAKE SHOE CLEARANCE