Home › Vehicle Interior › AIR CONDITIONING › PRESSURE SWITCH › from 2021.01
RM2850E _58 Vehicle Interior _073207 AIR CONDITIONING _0457162 PRESSURE SWITCH A

AIR CONDITIONING  PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 88645H 1.INSTALL NO. 1 PRESSURE SWITCH

a.

Remove the vinyl tape from the cooler refrigerant liquid pipe A and accessory assembly.


b.

Sufficiently apply compressor oil to the fitting surface of the cooler refrigerant liquid pipe A and No. 1 pressure switch.

Compressor Oil:

ND-OIL 8 or equivalent


NOTICE:

Do not use any compressor oil other than ND-OIL 8 or equivalent. If any compressor oil other than ND-OIL 8 or equivalent is used, compressor motor insulation performance may decrease, resulting in leakage of electric power.



c.
E424175C01
0.5,1.583 0.917,1.583 0.917,1.583 1.25,1.75 true 2.167,0.917 2.417,0.583 2.417,0.583 2.75,0.583 true 0.313,1.521 0.542,1.688 0.229,0.167 10 false *a 2.833,0.531 3.073,0.719 0.24,0.188 10 true *b
*a Turn
*b Hold


Using a 27 mm deep socket wrench, install the No. 1 pressure switch as shown in the illustration.

NOTICE:
·

Do not apply excessive force to the cooler refrigerant liquid pipe A.

·

Make sure not to cut the O-ring while installing it. (Cut O-rings cannot be installed)



Torque:
10.8 N*m (110 kgf*cm, 8 ft.*lbf)


d.

Connect the connector.


Hide 88471 2.INSTALL RECEIVER AIR CONDITIONING TANK

Hide 88716B 3.INSTALL COOLER REFRIGERANT LIQUID PIPE B

Hide 88716L 4.INSTALL COOLER REFRIGERANT LIQUID PIPE L

Hide 59401 5.INSTALL COOLER CONDENSER COVER SUB-ASSEMBLY

Hide 8.INSPECT FOR REFRIGERANT LEAK