1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
58521D
3.REMOVE ENGINE SERVICE HOLE COVER MAT
58410
4.REMOVE ENGINE SERVICE HOLE COVER
58734B
5.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP
58420
6.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58841A
7.REMOVE SHIFTING HOLE COVER
33820B
8.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
58701A
9.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
88310A
10.REMOVE NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT
16361A
11.REMOVE FAN AND GENERATOR V BELT
17113D
12.REMOVE INTAKE PIPE
17700
13.REMOVE AIR CLEANER ASSEMBLY
17341F
14.REMOVE NO. 1 AIR HOSE
27020
15.REMOVE GENERATOR ASSEMBLY
| *a | Terminal Cap |
| *b | Clamp |
Remove the terminal cap.
Detach the clamps.
| *a | Nut |
| *b | Connector |
| *c | Bolt |
Remove the nut and disconnect the terminal B.
Disconnect the connector.
Remove the 2 bolts and disconnect the wire harnesses from the generator bracket.
| *1 | Generator Bracket |
Remove the 3 bolts and the generator bracket.
Remove the bolt and the generator assembly.