Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch) › from 2021.01
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0356878 ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)  C1203  ECM Communication Circuit Malfunction  


DESCRIPTION

The engine control information from the ECM to the skid control ECU (brake actuator assembly) via CAN communication.

DTC No. DTC Detection Condition Trouble Area
C1203 Either of the following is detected:
1.

Engine model information sent from the ECM does not match the information stored in the skid control ECU.

2.

No system information stored in the skid control ECU.

3.

Incorrect installation of the skid control ECU or ECM.


·

ECM malfunction or ECM with incorrect part number installed

·

Skid control ECU (Brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>CALIBRATION).


PROCEDURE

1.CHECK PART NUMBER (ECM)
a.

Check that the proper ECM is installed.


Result:
Result Proceed to
Proper ECM is installed A
Proper ECM are not installed B


HINT:
Refer to the ECM removal procedures:
Engine Type See page
N04C-UH (Click here)
N04C-VQ (Click here)
N04C-VL (Click here)
N04C-WA (Click here)
2TR-FE (Click here)



A

2.CHECK BRAKE ACTUATOR ASSEMBLY

B

REPLACE ECM

2.CHECK BRAKE ACTUATOR ASSEMBLY
a.

Check if the brake actuator assembly had been replaced before the DTC was recorded.


Result:
Result Proceed to
The brake actuator assembly is not replaced A
The brake actuator assembly is replaced B



A

3.RECONFIRM DTC

B

4.PERFORM INITIALIZATION AND CALIBRATION
3.RECONFIRM DTC

b.

Turn the ignition switch off.



Result:
Result Proceed to
DTC C1203 is not output A
DTC C1203 is output B



A

B

4.PERFORM INITIALIZATION AND CALIBRATION

Result:
Proceed to
NEXT



NEXT

5.RECONFIRM DTC
5.RECONFIRM DTC

b.

Turn the ignition switch off.



Result:
Result Proceed to
DTC C1203 is not output A
DTC C1203 is output B



A

END

B