1.CHECK FOR INJECTOR COMPENSATION CODE
Check that the injection compensation code registered in the injector assembly installed on each cylinder match the ones registered in the ECM.
Click hereEngine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION
If they do not match, follow the procedures below to correct the registration details and recheck the symptom.
Correct the registration details by following the procedures in "register injection compensation code".
Click hereEngine / Hybrid System>N04C-UH (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION
After correcting the registration details, check if the same symptom occurs as when the vehicle was brought in.
If it does not occur, the symptom may be caused by errors in injection compensation code registration.
58410
2.REMOVE ENGINE SERVICE HOLE COVER
58734B
3.REMOVE ENGINE SERVICE COVER WEATHERSTRIP REAR
58521D
4.REMOVE ENGINE SERVICE HOLE COVER MAT
58420
5.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58534A
6.REMOVE TRANSMISSION COVER MAT
33531B
7.REMOVE SHIFT AND SELECT LEVER SHAFT DUST BOOT
33820B
8.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
33504F
9.REMOVE SHIFT LEVER SUB-ASSEMBLY
58701A
10.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
11.DRAIN ENGINE COOLANT
16206C
12.SEPARATE WATER BY-PASS PIPE SUB-ASSEMBLY
17113
13.REMOVE INTAKE PIPE
17271
14.REMOVE NO. 1 TURBO INSULATOR
25608
15.REMOVE EGR COOLER SUB-ASSEMBLY
12180E
16.REMOVE OIL FILLER CAP SUB-ASSEMBLY
Remove the oil filler cap.
11202D
17.REMOVE NO. 2 CYLINDER HEAD COVER SUB-ASSEMBLY
Remove the 2 bolts, the 2 stays and the No. 2 cylinder head cover.
11201
18.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
Disconnect the 5 connectors and remove the wire harness.
Remove the cylinder head cover cushion rubber.
Remove the 2 bolts, the 2 cushions, and the cylinder head cover.
Remove the gasket from the cylinder head cover.
23741B
19.REMOVE INJECTION PIPE CLAMP
Remove the 2 nuts and the 2 injection pipe clamps.
23670
20.REMOVE INJECTOR ASSEMBLY
Using a union nut wrench (17 mm), loosen the union nuts and disconnect the No. 1, No. 2, No. 3 and No. 4 injection pipes.
Using a small screwdriver, move the 4 holder seals.
Remove the union bolt, 4 hollow screws, 5 gaskets and nozzle leakage pipe.
After removing the nozzle leakage pipe, put it in a plastic bag to prevent foreign matter from contaminating its injector.
Remove the 4 bolts and 4 nozzle holder clamps.
Arrange the holder clamps and bolts in the correct order.
Remove the 4 injectors.
Arrange the injectors in the correct order.
Remove the No. 2 cylinder head cover gasket from each injector.
Engage tags to identify the cylinder (#1 to #4) to the injector assemblies so that each injector assembly can be inserted into the correct cylinder during installation.
Remove the O-ring from each injector.
| *1 | O-ring |
Remove the 4 injection nozzle seats from the cylinder head.