Home › Vehicle Interior › AIR CONDITIONING › COMPRESSOR (for 1HZ)
RM2850E _58 Vehicle Interior _073207 AIR CONDITIONING _0498911 COMPRESSOR(for 1HZ) A

AIR CONDITIONING  COMPRESSOR(for 1HZ)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 58521D 1.REMOVE ENGINE SERVICE HOLE COVER MAT

Hide 58410 2.REMOVE ENGINE SERVICE HOLE COVER

Hide 58734B 3.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58420 4.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58123A 5.REMOVE SHIFT AND SELECT LEVER SUPPORT WITH BOOTS

Hide 33506F 6.REMOVE FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY

Hide 58701A 7.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 8. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 88310A 9.REMOVE NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT

Hide 88712 10.DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE

a.
E471497C01
2.604,0.583 2.823,0.781 0.219,0.198 10 true *a 1.646,1.365 1.865,1.563 0.219,0.198 10 true *b
*a Connector
*b Bolt


Disconnect the connector.


b.

Remove the bolt and disconnect the No. 1 cooler refrigerant suction hose.


c.

Remove the O-ring from the No. 1 cooler refrigerant suction hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 88711 11.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.
E471498

Remove the bolt and No. 1 cooler refrigerant discharge hose.


b.

Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



Hide 12.REMOVE COMPRESSOR WITH MAGNETIC CLUTCH

a.
E471499

Remove the 4 bolts and compressor with magnet clutch.


Hide 88444 13.REMOVE IDLE PULLEY BRACKET

a.
E471500

Remove the 3 bolts and idle pulley bracket.


Hide 88431 14.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET

a.
E471501

Remove the 5 bolts and No. 1 compressor mounting bracket.