RM24M0E
_V1
General
_059537
INTRODUCTION
_0291663
REPAIR INSTRUCTION
D
INTRODUCTION REPAIR INSTRUCTION INITIALIZATION
| System Name
|
| Lighting System (w/ AFS)
|
| Parking Assist Monitor System
|
| Power Slide Door System
|
| Power Back Door System
|
- NOTICE:
-
After the engine switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
Procedures necessary when battery terminal is disconnected / reconnected
| Necessary Procedures
|
Procedure Details
|
Effects / Inoperative Functions When Necessary Procedures are not Performed
|
Notes
|
| w/ AFS: Store steering angle sensor neutral point
|
Drive the vehicle at more than 20 km/h (12mph) for more than 5 minutes on a straight road, with as little traffic congestion as possible.
|
AFS
|
Neutral point storage may also be performed manually (see page ( ))
|
| w/ Parking Assist Monitor System: Store steering angle neutral point
|
When steering wheel is turned fully to the left and right while driving on a flat, level road, the steering angle neutral point is corrected.
|
·
Parking Assist Monitor System
·
Multi-display indicates "System initializing"
|
Neutral point storage may also be performed manually (see page ( ))
|
| Reset slide door closed position
|
Close the slide door fully to turn off the courtesy switch
|
|
If the slide door is closed when disconnecting the cable from the battery terminal, it is not necessary to reset it.
|
| Initialize power back door
|
Close the slide door fully to turn off the courtesy switch
|
|
If the back door is closed when disconnecting the cable from the battery terminal, it is not necessary to reset it.
|