Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › SFI SYSTEM › from 2016.05
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291770 SFI SYSTEM D

2GR-FE ENGINE CONTROL  SFI SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


HINT:

Inspect the vehicle's ECM using check mode. Intermittent problems are easier to detect with an intelligent tester when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2 trip detection logic.

1.

Clear the DTCs.

2.

Switch the ECM from normal mode to check mode using an intelligent tester (See page Engine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>CHECK MODE PROCEDURE).

4.

Check and wiggle the harness(es), connector(s) and terminal(s) (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE).