Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › SFI SYSTEM › 2014.09–2016.05
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291770 SFI SYSTEM C

2GR-FE ENGINE CONTROL  SFI SYSTEM  U0129  Lost Communication with Skid Control ECU  


DESCRIPTION

The engine control unit intercommunicates with the skid control ECU with the Controller Area Network (CAN).

If there is a problem in this intercommunication, the ECM sets a DTC.

DTC No. DTC Detection Condition Trouble Area
U0129

Following conditions are met for 2 seconds (1 trip detection logic):

(a)

Engine switch on (IG)

(b)

Battery voltage is 10.5 V or more

(c)

No intercommunication between engine control ECU and skid control ECU



ECM

PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC U0129)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the tester on.


d.

Enter the following menus: Powertrain / Engine / DTC.


e.

Read DTCs.

Result
Result Proceed to
DTC U0129 is output A
DTC U0129 and other DTCs are output B



A

B