1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
85291B
2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
Remove the front wiper arm and blade assembly (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).
85291A
3.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
55742A
4.REMOVE HOOD TO COWL TOP SEAL
55781F
5.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
6.REMOVE COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK
Remove the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).
22204
7.REMOVE MASS AIR FLOW METER
Disconnect the mass air flow meter connector.
Remove the 2 screws and mass air flow meter.