Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291771 MASS AIR FLOW METER G

2GR-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the MAF meter inspection according to the procedures below.

·

Only replace the MAF meter when the MAF value in the Data List (with the engine stopped) are not within the normal operating range or there is foreign matter on the MAF meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.
B135940E01
0.425,2.845 1.557,3.021 1.132,0.177 10 Intelligent Tester 0.6,2.589 0.6,2.832 false 1.48,2.058 1.864,2.214 0.385,0.156 10 DLC3 1.717,2.051 1.841,1.732 false

Read the value using the intelligent tester (MAF).

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the MAF meter while it is installed to the air cleaner case (installed to the vehicle).

·

During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.



i.

Turn the ignition switch to the ON position (do not start the engine).


ii.

Turn the tester ON.


iii.

Select the following menu items: Powertrain / Engine and ECT / Data List / Primary / MAF.


iv.

Wait 30 seconds, and read the values on the intelligent tester.

Standard condition:

Below 0.49 g/sec.


·

If the result is not as specified, replace the MAF meter.

·

If the result is within the specified range, inspect the cause of the extremely rich or lean air-fuel ratio (See page Engine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>P0171).