Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291773 CRANKSHAFT POSITION SENSOR A

2GR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 2.REMOVE COMPRESSOR AND MAGNETIC CLUTCH

a.

Remove the compressor and magnetic clutch from the vehicle (See page Vehicle Interior>AIR CONDITIONING>COMPRESSOR(for 2GR-FE)>REMOVAL).


Hide 19315 3.REMOVE CRANKSHAFT POSITION SENSOR

a.
A076417

Disconnect the sensor connector.


b.

Remove the connector clamp.


c.

Remove the wire harness from the wire harness clamp bracket.


d.

Remove the wire harness clamp.


e.

Remove the bolt and crankshaft position sensor.