Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM24M0E _51 Engine / Hybrid System _059540 2GR-FE ENGINE CONTROL _0291782 ACCELERATOR PEDAL A

2GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

This accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubrication to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.
A137221

Install the accelerator pedal sensor with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


b.

Connect the accelerator pedal sensor connector.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 3.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.