Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2013.04–2016.05
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291785 CRANKSHAFT POSITION SENSOR A

2AZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Check whether the engine is TMC made or not by referring to the following illustration.

U188507E01
3.93,0.096 4.173,0.285 0.243,0.189 10 *B 0.339,0.096 0.588,0.285 0.249,0.189 10 *A 2.471,0.822 2.640,0.977 0.169,0.154 10 *1 2.471,0.932 2.045,1.143 false 6.069,0.84 6.239,0.994 0.169,0.154 10 *1 6.069,0.964 5.767,1.216 false 4.061,1.835 4.230,1.989 0.169,0.154 10 *2 6.342,1.937 6.511,2.092 0.169,0.154 10 *3 4.233,1.894 4.774,1.749 false 6.33,2.025 5.924,2.109 false

Text in Illustration
*A for TMC Made Engine *B except TMC Made Engine
*1 Engine Oil Level Dipstick Guide *2 Water Inlet Housing
*3 Water Inlet Housing Drain Cock Assembly - -


PROCEDURE

Hide 11301K 1.INSTALL CRANK POSITION SENSOR (for TMC Made Engine)

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing it.


a.
A095436E24
1.76,1.292 1.427,1.51 false 0.833,1.469 1.292,1.656 0.458,0.188 10 false O-Ring

Apply a light coat of engine oil to the O-ring of the crank position sensor.


b.
A194008

Install the crank position sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


c.

Install the 2 wire harness clamps.


d.

Install the connector to the connector bracket.


e.
A192489

Connect the crank position sensor connector.


Hide 11301K 2.INSTALL CRANK POSITION SENSOR (except TMC Made Engine)

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing it.


a.
A095436E24
1.76,1.292 1.427,1.51 false 0.833,1.469 1.292,1.656 0.458,0.188 10 false O-Ring

Apply a light coat of engine oil to the O-ring on the crank position sensor.


b.
A194009

Install the crank position sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


c.

Install the wire harness clamp.


d.

Install the connector to the connector bracket.


e.
A192489

Connect the crank position sensor connector.


Hide 27020 3.INSTALL GENERATOR ASSEMBLY