Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2016.05
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291785 CRANKSHAFT POSITION SENSOR A

2AZ-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANK POSITION SENSOR

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing it.


a.
A095436E24
1.76,1.292 1.427,1.51 false 0.833,1.469 1.292,1.656 0.458,0.188 10 false O-Ring

Apply a light coat of engine oil to the O-ring of the crank position sensor.


b.
A194008

Install the crank position sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


c.

Install the 2 wire harness clamps.


d.

Install the connector to the connector bracket.


e.
A192489

Connect the crank position sensor connector.


Hide 27020 2.INSTALL GENERATOR ASSEMBLY