The battery supplies electricity to the ECM even when the engine switch is in the off position. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the memory is cleared and the ECM determines that there is a malfunction in the power supply circuit. When the engine is next started, the ECM will illuminate the MIL and sets the DTC.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0560 | Open in ECM back-up power source circuit
(1 trip detection logic) |
·
Open in back-up power source circuit ·
Battery ·
Battery terminals ·
EFI fuse ·
ECM |
If DTC P0560 is set, the ECM does not store other DTCs or the data stored in the ECM are partly erased.
Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A7-20 (BATT) - Body ground | Always | 11 to 14 V |
OK
NG
Check that the battery is not depleted.
Battery is not depleted.
OK
NG
Check that the battery terminals are not loose or corroded.
Battery terminals are not loose or corroded
OK
NG
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester ON.
Clear DTCs (see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch off and turn the tester OFF.
Start the engine and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT/ DTC.
Read DTCs.
| Display (DTC Output) | Proceed to |
|---|---|
| P0560 | A |
| No output | B |
A
B