The throttle actuator is operated by the ECM and opens and closes the throttle valve using gears.
The opening angle of the throttle valve is detected by the throttle position sensor, which is mounted on the throttle body assembly. The throttle position sensor provides feedback to the ECM. This feedback allows the ECM to appropriately control the throttle actuator and monitor the throttle opening angle as the ECM responds to driver inputs.
This Electronic Throttle Control System (ETCS) does not use a throttle cable.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P2102 | Both of the following conditions continue for 2.0 seconds (1 trip detection logic):
(a) The throttle actuator drive duty cycle is 80% or higher. (b) The throttle actuator current is less than 0.5 A. |
·
Open in throttle actuator circuit ·
Throttle actuator ·
ECM |
| P2103 | Either of the following conditions is met (1 trip detection logic):
·
A hybrid IC diagnosis signal failure. ·
A hybrid IC high current limiter monitor input failure. |
·
Short in throttle actuator circuit ·
Throttle actuator ·
Throttle valve ·
Throttle body assembly ·
ECM |
When either of these DTCs or other DTCs relating to Electronic Throttle Control System (ETCS) malfunctions are stored, the ECM enters fail-safe mode. During fail-safe mode, the ECM cuts the current to the throttle actuator, and the throttle valve is returned to a 6.5° throttle angle by the return spring. The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel-cut) and ignition timing, in accordance with the accelerator pedal opening angle, to allow the vehicle to continue running at a minimal speed. If the accelerator pedal is depressed firmly and gently, the vehicle can be driven slowly.
Fail-safe mode continues until a pass condition is detected, and the engine switch is then turned off.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
The throttle actuator current (Throttle Motor Current) and the throttle actuator duty ratio (Throttle Motor Duty (Open) / Throttle Motor Duty (Close)) can be read using the GTS. However, the ECM shuts off the throttle actuator current when the electronic throttle control system malfunctions.
Inspect the throttle body assembly (See page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>THROTTLE BODY>INSPECTION).
OK
NG
Disconnect the throttle body assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D41-2 (M+) - D2-42 (M+) | Always | Below 1 Ω |
| D41-1 (M-) - D2-41 (M-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D41-2 (M+) or D2-42 (M+) - Body ground | Always | 10 kΩ or higher |
| D41-1 (M-) or D2-41 (M-) - Body ground | Always | 10 kΩ or higher |
OK
NG
Check for foreign objects between the throttle valve and the housing.
No foreign object between throttle valve and housing.
OK
NG
Check if the throttle valve opens and closes smoothly.
Throttle valve opens and closes smoothly.
OK
NG