Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › THROTTLE BODY
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291793 THROTTLE BODY A

2AZ-FE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 85110 3.REMOVE COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Remove the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).


Hide 17705 4.REMOVE AIR CLEANER CAP

a.
A132372

Disconnect the mass air flow meter connector and clamp.


b.
A132371

Disconnect the purge VSV, clamp and purge line hose.


c.
A132373

Disconnect the No. 2 ventilation hose from the cylinder head cover.


d.
A132374

Lock the No. 1 air cleaner hose clamp, and then disconnect the air cleaner cap from the throttle body.


e.
A132376

Unfasten the 2 hook clamps, and then remove the air cleaner cap.


f.

Remove the air cleaner filter element from the air cleaner case.


Hide 22210 5.REMOVE THROTTLE BODY

a.
A229370

Disconnect the purge line hose from the throttle body.


b.

Disconnect the No. 1 water by-pass hose from the throttle body.


c.

Disconnect the No. 2 water by-pass hose from the throttle body.


d.

Disconnect the throttle position sensor and control motor connector.


e.

Disconnect the wire harness clamp.


f.

Disconnect the fuel tube from the clamp.


g.
A229371

Remove the 4 bolts, and then remove the fuel pipe support and throttle body.


h.
A124566

Remove the gasket from the intake manifold.