Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › SFI SYSTEM › 2013.04–2016.05
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291789 SFI SYSTEM C

2AZ-FE ENGINE CONTROL  SFI SYSTEM  P1602  Deterioration of Battery  


DESCRIPTION

The ECM determines the battery power according to the voltage of the BATT terminal while the engine is running (not cranking).

DTC No. DTC Detection Condition Trouble Area
P1602 Battery power is 0%
·

Battery

·

ECM back-up power source circuit



CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


PROCEDURE

1.INSPECT BATTERY
a.

Inspect the battery specific gravity.

i.

Check the specific gravity of each cell.

Standard gravity:

1.25 to 1.29 at 20°C (68°F)




b.

Inspect the battery voltage.

i.

After the vehicle is driven for 20 minutes, stop the engine.


ii.

Turn the engine switch on (IG), and turn on the headlights, blower fan and defogger for 1 minute.


iii.

Turn the engine switch off.


iv.

Measure the battery voltage.

Standard voltage:

12.5 to 12.9 V at 20°C (68°F)





OK

NG

REPLACE BATTERY