Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291794 CAMSHAFT OIL CONTROL VALVE A

2AZ-FE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 85110 2.REMOVE COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Remove the cowl top outer panel with windshield wiper motor and link (see page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).


Hide 11101J 3.REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.
A132368

Disconnect the oil control valve connector.


b.

Remove the bolt and oil control valve.