Home › Engine / Hybrid System › 2AZ-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM24M0E _51 Engine / Hybrid System _059541 2AZ-FE ENGINE CONTROL _0291795 ACCELERATOR PEDAL A

2AZ-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL ROD ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal.

·

Do not disassemble the accelerator pedal assembly.

·

This accelerator pedal does not require lubrication.

·

Do not apply oil or other lubrication to the accelerator pedal. If applied, the accelerator pedal must be replaced.



a.
A137221

Install the accelerator pedal rod with the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


b.

Connect the accelerator pedal position sensor connector.


Hide 28800 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 3.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.