Home › Engine / Hybrid System › 2GR-FE EMISSION CONTROL › HEATED OXYGEN SENSOR
RM24M0E _51 Engine / Hybrid System _059544 2GR-FE EMISSION CONTROL _0291812 HEATED OXYGEN SENSOR A

2GR-FE EMISSION CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 89465A 2.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

a.

Disconnect the sensor connector under the center console.


b.
A135138E02
1.479,0.542 0.698,0.542 false 0.333,0.448 0.698,0.667 0.365,0.219 10 true SST

Using SST, remove the heated oxygen sensor.

SST
09224-00010  


Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

Disconnect the heated oxygen sensor (for Bank 2 Sensor 2) connector.


b.
A395328

Remove the 2 nuts.


c.
A395327

Remove the 2 bolts and No. 1 exhaust pipe support bracket.


d.
A395326

Remove the 2 bolts and front exhaust pipe assembly.


e.

Remove the 2 gaskets.


Hide 89465 4.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

a.
A135143E01
0.221,0.581 0.525,0.747 0.303,0.165 10 SST 1.195,0.67 0.59,0.67 false

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

SST
09224-00010