Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM24M0E _51 Engine / Hybrid System _059547 2GR-FE ENGINE MECHANICAL _0291828 FRONT CRANKSHAFT OIL SEAL A

2GR-FE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 53736 2.REMOVE FRONT FENDER APRON SEAL RH

Hide 13471 5.REMOVE CRANKSHAFT PULLEY

a.
A119083E01
1.019,0.372 1.378,0.571 0.358,0.199 10 SST 2.122,0.459 1.397,0.459 false 2.584,1.885 2.942,2.083 0.358,0.199 10 SST 2.534,1.983 1.836,2.412 false

Using SST, loosen the crankshaft pulley bolt.

SST
09213-70011  (09213-70020)
09330-00021  


b.
A119085E01
1.185,0.415 1.544,0.612 0.359,0.198 10 SST 2.182,0.501 1.568,0.501 false 2.428,2.448 2.788,2.646 0.359,0.198 10 SST 2.388,2.529 1.775,2.529 false

Using SST, remove the crankshaft pulley bolt and crankshaft pulley.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)


c.

Remove the pulley set key from the crankshaft.


Hide 11301C 6.REMOVE TIMING CHAIN CASE OIL SEAL

a.
A141580E12
0.427,1.458 0.427,0.823 false 1.771,1.042 2.125,0.563 false 0.021,0.406 0.792,0.552 0.771,0.146 10 false Cut Position 2.146,0.469 3.229,0.833 1.083,0.365 10 true Protective Tape

Using a knife, cut off the oil seal lip.


b.

Using a screwdriver, pry out the oil seal.

NOTICE:

After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.


HINT:

Tape the screwdriver tip before use.