Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM24M0E _51 Engine / Hybrid System _059547 2GR-FE ENGINE MECHANICAL _0291829 REAR CRANKSHAFT OIL SEAL A

2GR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11381A 1.INSTALL ENGINE REAR OIL SEAL

a.
A132245E06
2.115,1.156 2.688,1.417 false 2.125,3.198 2.594,2.958 false 1.51,2.698 0.719,2.698 false 2.708,1.323 3.021,1.479 0.313,0.156 10 false SST 2.625,2.865 2.938,3.021 0.313,0.156 10 false SST 0.031,2.625 0.604,2.781 0.573,0.156 10 false Retainer 2,2.375 2.948,2.698 0.948,0.323 10 true -0.5 to 0.5 mm

Apply MP grease to a new oil seal lip.


b.

Using SST and a hammer, tap in the oil seal.

SST
09223-15030  
09950-70010  (09951-07150)

Oil seal tap in depth:

-0.5 to 0.5 mm (-0.020 to 0.020 in.)



Hide 32101 2.INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

a.
A129631E01
0.251,1.23 0.570,1.414 0.319,0.184 10 SST 1.429,0.75 0.655,1.325 0.655,1.325 1.727,1.117 false

Using SST, hold the crankshaft.

SST
09213-70011  (09213-70020)
09330-00021  


b.
P000601E46
1.406,1.354 1.594,0.427 1.594,0.427 1.729,0.427 false 1.75,0.344 2.396,0.49 0.646,0.146 10 false Adhesive

Apply adhesive to 2 or 3 threads of the mounting bolt end.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



c.
A132243E08
1.875,0.292 2.031,0.469 0.156,0.177 10 true 1 2.302,0.552 2.458,0.74 0.156,0.188 10 true 7 2.5,0.865 2.646,1.052 0.146,0.188 10 true 4 2.313,1.396 2.458,1.563 0.146,0.167 10 true 6 1.854,1.563 1.979,1.719 0.125,0.156 10 true 2 1.417,1.438 1.542,1.594 0.125,0.156 10 true 8 1.104,0.969 1.271,1.146 0.167,0.177 10 true 3 1.323,0.396 1.49,0.583 0.167,0.188 10 true 5

Install the front spacer, drive plate and rear spacer on the crankshaft.


d.

Install and tighten the 8 mounting bolts uniformly in several steps.

Torque:
83 N*m (850 kgf*cm, 61 ft.*lbf)