Home › Engine / Hybrid System › 2AZ-FE EXHAUST › EXHAUST PIPE
RM24M0E _51 Engine / Hybrid System _059550 2AZ-FE EXHAUST _0291838 EXHAUST PIPE A

2AZ-FE EXHAUST  EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 17410 1.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.
A077857

Using a vernier caliper, measure the free length of the compression spring.

Minimum length:

41.5 mm (1.634 in.)


If the length is less than the minimum, replace the compression spring.


b.
A138040E01
2.252,0.009 3.217,0.191 0.964,0.182 10 Wooden Block 0.686,1.735 1.189,1.917 0.503,0.182 10 Gasket 1.957,1.498 1.484,1.826 false 2.271,0.478 2.038,0.297 false 2.038,0.297 2.038,0.093 false 2.032,0.093 2.185,0.093 false 1.484,1.826 1.287,1.826 false

Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the exhaust manifold.

NOTICE:
·

Tap in the gasket in the correct direction.

·

Do not reuse the removed gasket.

·

Do not push in the gasket while installing the front exhaust pipe.




c.
A393987

Install the front exhaust pipe with the 2 compression springs and 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 17420 2.INSTALL CENTER EXHAUST PIPE ASSEMBLY

a.

Install a new gasket onto the front exhaust pipe.


b.
A393986

Connect the 2 exhaust pipe supports to install the center exhaust pipe.


c.

Install the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 17430 3.INSTALL TAILPIPE ASSEMBLY

a.
A077857

Using a vernier caliper, measure the free length of the compression spring.

Minimum length:

38.5 mm (1.516 in.)


If the length is less than the minimum, replace the compression spring.


b.
A133205E01
2.608,1.565 3.146,1.742 0.538,0.177 10 Gasket 2.585,1.633 2.401,1.538 false

Install a new gasket by hand so that its surface is flush with the center exhaust pipe.

NOTICE:
·

Make sure the gasket is facing the correct direction.

·

Do not reuse the removed gasket.

·

Do not push in the gasket while installing the tailpipe.




c.
A393985

Connect the 3 exhaust pipe supports to install the tailpipe.


d.

Install the 2 compression springs and 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 89465 4.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

Hide 28800 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 7.CHECK FOR EXHAUST GAS LEAKS

If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.