1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
74404B
2.REMOVE BATTERY CLAMP SUB-ASSEMBLY
Remove the bolt, nut and battery clamp.
28800
3.REMOVE BATTERY
51441
4.REMOVE NO. 1 ENGINE UNDER COVER
5.DRAIN ENGINE COOLANT
16571C
6.DISCONNECT NO. 1 RADIATOR HOSE
Disconnect the No. 1 radiator hose from the No. 1 water by-pass pipe, engine and radiator.
16572D
7.DISCONNECT NO. 2 RADIATOR HOSE
32921
8.DISCONNECT NO. 1 OIL COOLER INLET TUBE (w/ Oil Cooler)
Disconnect the oil cooler hose inlet and outlet from the radiator.
Remove the 3 bolts and tube from the radiator.
81150
9.REMOVE HEADLIGHT ASSEMBLY (except LED Headlight)
Remove the headlight assembly (see page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(except LED Headlight)>REMOVAL).
81150
10.REMOVE HEADLIGHT ASSEMBLY (for LED Headlight)
Remove the headlight assembly (see page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(for LED Headlight)>REMOVAL).
53209B
11.REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY
Disconnect the 3 wire harness clamps from the hood lock support brace sub-assembly.
Remove the 2 bolts and hood lock support brace sub-assembly.
16268
12.REMOVE NO. 1 WATER BY-PASS PIPE
Detach the clamp from the radiator support.
Disconnect the No. 1 water by-pass hose from the reservoir.
Disconnect the No. 3 water by-pass hose from the radiator.
Remove the 2 bolts and No. 1 water by-pass pipe from the upper radiator support.
| *1 | No. 1 Water By-Pass Hose | *2 | No. 1 Water By-Pass Pipe |
| *3 | No. 3 Water By-Pass Hose | - | - |
13.DISCONNECT COOLING FAN MOTOR CONNECTOR
Disconnect the No. 1 and No. 2 fan motor connectors.
Detach the claw.
16533
14.REMOVE RADIATOR SUPPORT UPPER BRACKET
Remove the 4 bolts and 2 brackets.
17751
15.REMOVE NO. 1 AIR CLEANER INLET
Remove the clip and inlet.
53205
16.REMOVE RADIATOR UPPER SUPPORT SUB-ASSEMBLY
Remove the ground cable's bolt from the radiator support LH side.
Detach the 2 wire harness's clamps from the radiator support LH side.
Remove the 4 bolts and support with wire harness.
Do not excessively move the radiator upper support, as its movement is limited by the wire harness.
16712
17.REMOVE NO. 2 FAN SHROUD
Remove the 2 bolts and No. 2 fan shroud.
16400
18.REMOVE RADIATOR ASSEMBLY WITH FAN SHROUD AND FAN MOTOR
Detach the cooler condenser from the radiator.
After detaching the condenser, make sure that all 4 fan shroud cushions are present.
Remove the radiator with fan shroud and fan motor.
Remove the 2 lower radiator support cushions.
16711
19.REMOVE FAN SHROUD WITH FAN MOTOR
Remove the 2 bolts and fan shroud with fan motor from the radiator.