Home › Engine / Hybrid System › 2AZ-FE COOLING › THERMOSTAT
RM24M0E _51 Engine / Hybrid System _059552 2AZ-FE COOLING _0291854 THERMOSTAT A

2AZ-FE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.

Install a new gasket onto the thermostat.


b.
A112199E12
1.823,1.031 1.156,1.479 1.156,1.479 1.063,1.479 true 1.969,0.083 2.573,0.271 0.604,0.188 10 false Upward 0.177,1.365 0.969,1.729 0.792,0.365 10 true Jiggle Valve 1.896,0.51 2.146,0.708 0.25,0.198 10 true 10° 1.552,0.49 1.802,0.677 0.25,0.188 10 true 10°

Install the thermostat with the jiggle valve facing upward.

HINT:

The jiggle valve can be set to within 10° on either side of the prescribed position.



Hide 16321 2.INSTALL WATER INLET

a.
A132506

Install the water inlet with the 2 nuts.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)


Hide 16571 3.CONNECT NO. 2 RADIATOR HOSE

A114376

Hide 53292A 6.INSTALL UPPER RADIATOR SUPPORT SEAL

Hide 51441 7.INSTALL NO. 1 ENGINE UNDER COVER