Home › Engine / Hybrid System › 2GR-FE LUBRICATION › LUBRICATION SYSTEM
RM24M0E _51 Engine / Hybrid System _059553 2GR-FE LUBRICATION _0291856 LUBRICATION SYSTEM G

2GR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark.

If the engine oil level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not add engine oil above the full level mark.



Hide 2.CHECK ENGINE OIL QUALITY

a.

Check the engine oil for deterioration, water contamination, discoloring or thinning.

If the oil is bad, replace the engine oil and engine oil filter.


Hide 3.CHECK OIL PRESSURE

a.
A136987

Remove the No. 2 engine under cover.


b.

Disconnect the oil pressure switch connector.


c.

Remove the wire harness from the bracket.


d.

Remove the bolt and separate the bracket from the compressor.


e.
A127994

Using a 24 mm deep socket wrench, remove the oil pressure switch.


f.
A127995

Install the oil pressure gauge with adapter.


g.

Warm up the engine.


h.

Check the oil pressure.

Standard oil pressure:
Engine Condition Oil Pressure
Idle 80 kPa (0.8 kgf/cm2, 11.6 psi) or more
3000 rpm 380 kPa (3.9 kgf/cm2, 55.5 psi) or more


If the oil pressure is not as specified, check the oil pump (See page Engine / Hybrid System>2GR-FE LUBRICATION>OIL PUMP>INSPECTION).


i.
A395904E01
1.927,0.698 1.323,0.354 false 0.698,0.24 1.927,0.438 1.229,0.198 10 false Adhesive

Remove the oil pressure gauge.


j.

Apply adhesive to 2 or 3 threads of the oil pressure switch.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



k.
A127994

Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour after installation.



l.
A137809

Install the bracket to the compressor with the bolt.

Torque:
25 N*m (254 kgf*cm, 18 ft.*lbf)


m.

Install the wire harness to the bracket.


n.

Connect the oil pressure switch connector.


o.

Check for engine oil leaks.


p.

Install the No. 2 engine under cover.