Home › Drivetrain › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM › from 2016.05
RM24M0E _52 Drivetrain _059557 TIRE AND WHEEL _0291871 TIRE PRESSURE WARNING SYSTEM C

TIRE AND WHEEL  TIRE PRESSURE WARNING SYSTEM  C2111/11  Transmitter ID1 Operation Stop  C2112/12  Transmitter ID2 Operation Stop  C2113/13  Transmitter ID3 Operation Stop  C2114/14  Transmitter ID4 Operation Stop  C2115/15  Transmitter ID5 Operation Stop  


DESCRIPTION

The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressure of each wheel. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measured tire pressure values with the tire pressure threshold. When the measured tire pressure value is less than this threshold, the warning light in the combination meter sub-assembly illuminates. The tire pressure warning ECU and receiver stores a DTC when the tire pressure warning valve and transmitter stops transmitting signals. The signals can be forcibly transmitted by releasing the tire pressure rapidly. The stored DTC is cleared when signal transmission resumes.

DTC No. DTC Detection Condition Trouble Area
C2111/11
C2112/12
C2113/13
C2114/14
C2115/15*
Tire pressure warning valve and transmitters stop transmitting signals
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver



*: w/ Full Size Spare Tire

HINT:

It is necessary to perform the following procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because it cannot be identified by the output DTC.


WIRING DIAGRAM

C358819E02
5.948,4.542 6.427,4.708 0.479,0.167 10 false CLSW 5.729,4.406 5.938,4.573 0.208,0.167 10 false 7 5.948,5.302 6.427,5.469 0.479,0.167 10 false GND 5.667,5.177 5.896,5.344 0.229,0.167 10 false 12 2.615,4.406 2.76,4.573 0.146,0.167 10 false 2 2.594,4.625 2.74,4.792 0.146,0.167 10 false E 3.219,4.625 3.458,4.792 0.24,0.167 10 false INT 3.323,4.406 3.469,4.573 0.146,0.167 10 false 1 5.667,6.052 7.073,6.583 1.406,0.531 10 false Tire Pressure Warning ECU and Receiver 2.188,5.094 4.49,5.26 2.302,0.167 10 false Tire Pressure Warning Reset Switch 0.156,5.906 2.458,6.073 2.302,0.167 10 false *: Full Size Spare Tire 5.667,5.875 6.021,6.042 0.354,0.167 10 false M44 2.813,0.417 4.917,0.771 2.104,0.354 10 false Tire Pressure Warning Valve and Transmitter 0.302,1.146 2.406,1.5 2.104,0.354 10 false Tire Pressure Warning Valve and Transmitter 2.823,1.865 4.917,2.219 2.094,0.354 10 false Tire Pressure Warning Valve and Transmitter 2.771,3.375 4.865,3.729 2.094,0.354 10 false Tire Pressure Warning Valve and Transmitter* 0.281,2.594 2.417,2.948 2.135,0.354 10 false Tire Pressure Warning Valve and Transmitter 0.583,6.333 1.667,6.552 1.083,0.219 10 false : Radio Waves 2.188,4.906 2.646,5.083 0.458,0.177 10 false G110

PROCEDURE

1.PERFORM FORCED TRANSMISSION OF TRANSMITTER ID OF ALL WHEELS
a.

Set the tire pressure to the specified value (See page Drivetrain>TIRE AND WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION).


b.

Turn the engine switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the engine switch on (IG).


e.

Turn the GTS on.


f.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


g.

Read the Data List according to the display on the GTS.

Tire Pressure Monitor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
ID 1 Tire Inflation Pressure ID1 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 2 Tire Inflation Pressure ID2 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 3 Tire Inflation Pressure ID3 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 4 Tire Inflation Pressure ID4 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID 5 Tire Inflation Pressure*2 ID5 tire inflation pressure/
min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1

HINT:
·

*1: It may take a few minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2124/24 (C2125/25: w/ Full Size Spare Tire) (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>C2121/21).

·

*2: w/ Full Size Spare Tire




h.

Rapidly reduce the tire pressure for each wheel at least 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.

i.

Check that each "ID Tire Inflation Pressure" value displayed on the GTS has changed.

OK:

Each "ID Tire Inflation Pressure" value displayed on the GTS changed to the actual tire inflation pressure value.


NOTICE:
·

It may take a few minutes until the values are displayed.

·

When an "ID Tire Inflation Pressure" value has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the value.




ii.

After confirming that all of the tire "ID Tire Inflation Pressure" values displayed on the GTS have changed, set the tire pressure to the appropriate specified values.

HINT:

If an "ID Tire Inflation Pressure" value displayed on the GTS has not changed after rechecking, inspect for another problem (See page Drivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>C2121/21).





OK

END

NG

GO TO TRANSMITTER AND RECEIVER INSPECTION PROCEDURE