Home › Brake › BRAKE › FRONT BRAKE(for 16 inch Front Disc Brake)
RM24M0E _54 Brake _059558 BRAKE _0291877 FRONT BRAKE(for 16 inch Front Disc Brake) G

BRAKE  FRONT BRAKE(for 16 inch Front Disc Brake)  INSPECTION  


PROCEDURE

Hide 1.CHECK BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust or scoring.

If necessary, replace the cylinder and piston.


Hide 04465 2.CHECK PAD LINING THICKNESS

a.
C133405

Using a ruler, measure the pad lining thickness.

Standard thickness:

12.0 mm (0.472 in.)


Minimum thickness:

1.0 mm (0.039 in.)


If the pad lining thickness is equal to or less than the minimum, replace the pad.


Hide 47716 3.CHECK FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Check the 2 plates as follows. If necessary, replace the plates.

i.

Use brake cleaner to clean the pad support plate's pad and cylinder mounting contact surface. Inspect for deformation, cracks, rust and foreign matter that is difficult to remove.


ii.

Use brake cleaner to clean the cylinder mounting's pad support plate contact surface. After installing the pad support plate to the cylinder mounting, inspect for looseness and deformation.


iii.

After installing the pad, inspect if the pad falls off easily (due to the spring force of the pad support plate).



Hide 43512 4.CHECK DISC THICKNESS

a.
C133406

Using a micrometer, measure the disc thickness.

Standard thickness:

28.0 mm (1.102 in.)


Minimum thickness:

25.0 mm (0.984 in.)


If the disc thickness is less than the minimum, replace the disc.


Hide 5.CHECK DISC RUNOUT

a.

Check the axle hub bearing (see page Drivetrain>AXLE>FRONT AXLE HUB>ON-VEHICLE INSPECTION).


b.

Tighten the disc with the 5 hub nuts.

T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }


c.
C133407

Using a dial indicator, measure the disc runout 10.0 mm (0.39 in.) from the outer edge of the disc.

Maximum disc runout:

0.05 mm (0.00197 in.)


If the runout is greater than the maximum, change the installation positions of the disc and axle so that the runout will become minimal. If the runout is greater than the maximum even when the installation positions are changed, grind the disc. If the disc thickness is less than the minimum, replace the disc.


d.

Remove the 5 hub nuts.