Home › Brake › BRAKE › REAR BRAKE
RM24M0E _54 Brake _059558 BRAKE _0291879 REAR BRAKE A

BRAKE  REAR BRAKE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 47750A 1.INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH

NOTICE:

The rear disc brake cylinder has an identification mark. Make sure of the identification mark when installing the rear disc brake cylinder.

Item Identification Mark
Rear disc brake cylinder LH LH
Rear disc brake cylinder RH RH


U189394E02
1.521,0.917 1.656,1.719 false 1.104,1.74 2.302,1.927 1.198,0.188 10 false Identification Mark

a.
C138959E02
0.531,1.719 2.469,1.906 1.938,0.188 10 false Silicon Grease (Multemp SI-B)

Apply silicon grease (Multemp SI-B) on the contact surfaces of the cylinder parts indicated by the arrows.


b.
C138948

Install the cylinder with the 2 bolts.

Torque:
32 N*m (326 kgf*cm, 24 ft.*lbf)


Hide 47319F 2.CONNECT REAR FLEXIBLE HOSE LH

a.
C133741

Connect the flexible hose with a new gasket and a new union bolt.

Torque:
29 N*m (300 kgf*cm, 22 ft.*lbf)

HINT:

Install the flexible hose lock securely in the lock hole in the cylinder.



Hide 3.FILL RESERVOIR WITH BRAKE FLUID

Hide 4.BLEED AIR FROM BRAKE MASTER CYLINDER

Hide 5.BLEED AIR FROM BRAKE LINE

Hide 6.CHECK BRAKE FLUID LEVEL IN RESERVOIR

Hide 7.INSPECT FOR BRAKE FLUID LEAK

Hide 8.INSTALL REAR WHEEL

T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }