Home › Brake › BRAKE › REAR BRAKE
RM24M0E _54 Brake _059558 BRAKE _0291879 REAR BRAKE G

BRAKE  REAR BRAKE  INSPECTION  


PROCEDURE

Hide 1.CHECK BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust or scoring.

If necessary, replace the cylinder and piston.


Hide 04466 2.CHECK PAD LINING THICKNESS

a.
C133725

Using a ruler, measure the pad lining thickness.

Standard thickness:

10.0 mm (0.394 in.)


Minimum thickness:

1.0 mm (0.039 in.)


If the pad lining thickness is equal to or less than the minimum, replace the pad.


Hide 47716 3.CHECK REAR DISC BRAKE PAD SUPPORT PLATE

a.

Check the 4 plates as follows. If necessary, replace the plates.

i.

Use brake cleaner to clean the pad support plate's pad and cylinder mounting contact surface. Inspect for deformation, cracks, rust and foreign matter that is difficult to remove.


ii.

Use brake cleaner to clean the cylinder mounting's pad support plate contact surface. After installing the pad support plate to the cylinder mounting, inspect for looseness and deformation.


iii.

After installing the pad, inspect if the pad falls off easily (due to the spring force of the pad support plate).



Hide 42431 4.CHECK DISC THICKNESS

a.
C133726

Using a micrometer, measure the disc thickness.

Standard thickness:

10.0 mm (0.394 in.)


Minimum thickness:

8.5 mm (0.335 in.)


If the disc thickness is less than the minimum, replace the disc.


Hide 5.CHECK DISC RUNOUT

a.

Check the bearing backlash and axle hub deviation (see page Drivetrain>AXLE>REAR AXLE HUB>ON-VEHICLE INSPECTION).


b.

Tighten the disc with the 5 hub nuts.

T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }


c.
C133727

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the disc.

Maximum disc runout:

0.15 mm (0.00591 in.)


If the runout is greater than the maximum, change the installation positions of the disc and axle so that the runout will become minimal.

If the runout is greater than the maximum even when the installation positions are changed, grind the disc.

If the disc thickness is less than the minimum, replace the disc.


d.

Remove the 5 hub nuts.