Home › Brake › BRAKE › FRONT BRAKE(for 17 inch Front Disc Brake) › from 2016.05
RM24M0E _54 Brake _059558 BRAKE _0291884 FRONT BRAKE(for 17 inch Front Disc Brake) G

BRAKE  FRONT BRAKE(for 17 inch Front Disc Brake)  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the front disc brake cylinder bore and front disc brake piston for rust and scoring. If necessary, replace the front disc brake cylinder assembly and front disc brake piston.


Hide 2.INSPECT PAD LINING THICKNESS

a.
C165886E03
2.194,1.034 2.452,0.594 2.452,0.594 2.551,0.594 false 2.585,0.496 2.889,0.722 0.304,0.226 10 *a

Using a ruler, measure the front disc brake pad lining thickness.

Standard Thickness:

12.0 mm (0.472 in.)


Minimum Thickness:

1.0 mm (0.039 in.)


Text in Illustration
*a Ruler

HINT:
·

If a front disc brake pad lining thickness is less than the minimum thickness, replace the front disc brake pads.

·

Be sure to check front disc thickness when replacing the front disc brake pads with new ones.




Hide 3.INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE

a.

Make sure that the front disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt is cleaned off. If necessary, replace the front disc brake pad support plates.


Hide 4.INSPECT DISC THICKNESS

a.
C356425E02
2.375,1.208 2.563,1.844 2.563,1.844 2.708,1.844 false 2.74,1.771 3.042,2.021 0.302,0.25 10 false *a

Using a micrometer, measure the front disc thickness.

Standard Thickness:

28.0 mm (1.102 in.)


Minimum Thickness:

25.0 mm (0.984 in.)


Text in Illustration
*a Micrometer

HINT:

If the front disc thickness is less than the minimum thickness, replace the front disc.



Hide 5.INSPECT DISC RUNOUT

a.

Inspect the front axle hub bearing looseness and front axle hub runout.(See page Drivetrain>AXLE>FRONT AXLE HUB>ON-VEHICLE INSPECTION)


b.

Temporarily install the front disc with the 5 hub nuts.

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)


c.
C192807E05
1.844,1.052 2.313,1.052 false 2.344,0.958 2.646,1.156 0.302,0.198 10 false *a

Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the front disc.

Text in Illustration
*a Dial Indicator

Maximum Disc Runout:

0.05 mm (0.00197 in.)


NOTICE:

Keep the magnet of the dial indicator away from the front speed sensor.


HINT:

If the runout exceeds the maximum value, change the installation position of the front disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, grind the front disc. If the front disc thickness is less than the minimum, replace the front disc.



d.

Remove the 5 hub nuts and front disc.