Home › Brake › PARKING BRAKE › PARKING BRAKE ASSEMBLY
RM24M0E _54 Brake _059559 PARKING BRAKE _0291888 PARKING BRAKE ASSEMBLY A

PARKING BRAKE  PARKING BRAKE ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

Hide 42491 3.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

a.

Remove the shoe adjusting hole plug from the rear disc.


Hide 42431 4.REMOVE REAR DISC

a.
C133389E03
2.462,0.05 3.243,0.227 0.781,0.177 10 Matchmark 1.821,1.035 2.405,0.162 2.405,0.162 1.815,1.179 false

Put matchmarks on the disc and axle hub.


b.

Release the parking brake.


c.
C133390

Turn the shoe adjuster until the disc turns freely, and then remove the disc.


d.

Install the shoe adjusting hole plug to the rear disc.


Hide 46550A 5.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Upper Side)

a.
C133391

Using needle-nose pliers, remove the 2 shoe return tension springs.


Hide 47614 6.REMOVE PARKING BRAKE SHOE STRUT LH

Hide 47613D 7.REMOVE PARKING BRAKE SHOE STRUT COMPRESSION SPRING

Hide 46550E 8.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING (for Lower Side)

a.

Using needle-nose pliers, remove the tension spring.


Hide 47406A 9.REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET

a.

Remove the screw set.


Hide 46580 10.REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH

a.
C133392E02
2.489,0.451 2.846,0.623 0.357,0.172 10 SST 1.444,1.274 2.438,0.566 false

Using SST, remove the 2 shoe hold down spring cups, compression spring and pin.

SST
09718-00011  


b.

Remove the shoe.


Hide 46590 11.REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH

a.
C133393E02
2.487,0.484 2.840,0.643 0.353,0.159 10 SST 2.059,1.153 2.416,0.614 false

Using SST, remove the 2 shoe hold down spring cups, compression spring and pin.

SST
09718-00011  


b.

Remove the shoe.


c.

Disconnect the parking brake cable from the parking brake shoe lever.


Hide 47612 12.REMOVE PARKING BRAKE SHOE LEVER LH

a.
C133394

Using a screwdriver, remove the C-washer, shim and parking brake shoe lever.

HINT:

The shim is installed only when a clearance adjustment between the parking brake lever and C-washer is necessary. Therefore, some models may have no shim.



Hide 47456A 13.REMOVE PARKING BRAKE SHOE GUIDE PLATE

a.

Remove the guide plate set bolt and guide plate.