Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM
RM24M0E _55 Steering _059560 STEERING COLUMN _0291889 STEERING LOCK SYSTEM L

STEERING COLUMN  STEERING LOCK SYSTEM  PRECAUTION  


NOTICE FOR INITIALIZATION


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.


System Name See procedure
Power Slide Door System (Click here)
Power Back Door System
Parking Assist Monitor System
Lighting System


PRECAUTIONS WHEN WORKING ON ELECTRIC STEERING LOCK SYSTEM


a.

If the steering lock actuator has been replaced, open and close the driver door. The engine may not start until this operation is performed.

HINT:

Performing the above operation causes the steering lock actuator to store the correct steering lock bar position.



b.

When checking for DTCs of the push button start function or checking the Data List with the ignition switch off, make sure that the driver door is open.

HINT:

When the ignition switch is off, the main body ECU may not be working. Communication with the intelligent tester is impossible if the main body ECU is not working.




PRECAUTION FOR STEERING LOCK ACTUATOR


NOTICE:

If the steering lock actuator (steering lock ECU) is replaced, with the ignition switch off and the shift lever on P, open and close the driver side door to record the current steering lock position into the steering lock ECU. If this is not performed, the engine may not start.