Home › Steering › STEERING COLUMN › STEERING SYSTEM › from 2016.05
RM24M0E _55 Steering _059560 STEERING COLUMN _0291891 STEERING SYSTEM L

STEERING COLUMN  STEERING SYSTEM  PRECAUTION  


HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM


a.

Handling precautions for SRS airbag system (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).



HANDLING PRECAUTIONS FOR STEERING COLUMN


a.

When handling the steering column assembly:

i.

Avoid any impact to the steering column assembly, especially to the motor or the torque sensor. Replace it with a new one if it is dropped or subjected to any severe impacts.


ii.

Do not pull the wire harness when moving the steering column assembly.


iii.

When the steering column assembly or other steering-related parts have been removed and either reinstalled or replaced, perform steering center point adjustment (zero point calibration) (See page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).



b.

When disconnecting or reconnecting the connectors:

i.

When disconnecting connectors related to the electronic motor power steering system, turn the engine switch on (IG) (the engine is stopped), center the steering wheel, turn the engine switch off, and then disconnect the connectors.


ii.

When reconnecting connectors related to the electronic motor power steering system, make sure that the engine switch is turned off, center the steering wheel and then turn the engine switch on (IG) (the engine is stopped).

NOTICE:

Do not turn the engine switch on (IG) without the steering wheel being centered.



iii.

If the above operations are not carried out correctly, the steering center point (zero point) will deviate, causing a difference in steering effort between right and left turns. If there is a difference in the steering effort between right and left turns, perform the steering center point adjustment (zero point calibration) (See page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).