The torque sensor converts the rotation torque input from the steering wheel into electric signals and sends them to the power steering ECU.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1511 | Torque sensor malfunction | ·
Steering column (torque sensor) ·
Power steering ECU |
| C1512 | ||
| C1513 | ||
| C1514 | ||
| C1517 |
If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
Check the installation condition of the torque sensor connector.
Torque sensor connector is securely connected to the power steering ECU.
OK
NG
Turn the ignition switch on (IG).
Measure the voltage of the power steering ECU.
| Tester Connection | Specified Condition |
|---|---|
| A-6 (TRQV) - A-8 (TRQG) | 4.5 to 5.5 V |
OK
NG
Turn the ignition switch on (IG).
Measure the voltage of the power steering ECU.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A-5 (TRQ1) - A-8 (TRQG) | Steering wheel not turned (without load) | 2.3 to 2.7 V |
| Steering wheel turned to right with vehicle stopped | 2.5 to 3.8 V | |
| Steering wheel turned to left with vehicle stopped | 1.2 to 2.5 V | |
| A-7 (TRQ2) - A-8 (TRQG) | Steering wheel not turned (without load) | 2.3 to 2.7 V |
| Steering wheel turned to right with vehicle stopped | 1.2 to 2.5 V | |
| Steering wheel turned to left with vehicle stopped | 2.5 to 3.8 V |
Under each condition, measure the voltage at terminals TRQ1 and TRQ2, and calculate the sum.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Sum of voltage between A-5 (TRQ1) and A-8 (TRQG) and voltage between A-7 (TRQ2) and A-8 (TRQG) | Steering wheel not turned (without load) | Between 4.75 V and 5.25 V |
| Steering wheel turned to right with vehicle stopped | ||
| Steering wheel turned to left with vehicle stopped |
OK
NG