Home › Steering › POWER STEERING › POWER STEERING SYSTEM › 2013.04–2014.09
RM24M0E _55 Steering _059561 POWER STEERING _0291895 POWER STEERING SYSTEM C

POWER STEERING  POWER STEERING SYSTEM  C1552  PIG Power Supply Voltage Malfunction  


DESCRIPTION

When a problem occurs in the power steering system, the power source relay circuit is shut off to stop the power assist.

DTC No. DTC Detection Condition Trouble Area
C1552 PIG power source circuit malfunction inside ECU
·

PIG power source circuit

·

Power steering ECU



WIRING DIAGRAM

C137253E03
2.604,0.958 2.906,1.177 0.302,0.219 10 false EPS 4.625,0.74 4.885,0.885 0.26,0.146 10 false PIG 4.625,2.188 5.052,2.333 0.427,0.146 10 false PGND 4.365,0.615 4.604,0.854 0.24,0.24 10 false 1 4.365,2.042 4.583,2.313 0.219,0.271 10 false 2 4.708,3.198 6.052,3.438 1.344,0.24 10 false Power Steering ECU 4.708,3.021 5.167,3.219 0.458,0.198 10 false A21

CAUTION / NOTICE / HINT

NOTICE:

If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (PIG POWER SUPPLY)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and press the intelligent tester main switch ON.


c.

Select the item "PIG power supply" in the Data List and read the value displayed on the intelligent tester.

Power steering ECU
Item Item Description: Range (Display) Normal Condition Diagnostic Note
PIG power supply PIG power supply:
Min.: 0 V
Max.: 20.1531 V
10 to 14 V PIG steering in operation



NG

2.CHECK WIRE HARNESS (POWER STEERING ECU - BATTERY AND BODY GROUND)

OK

CHECK INTERMITTENT PROBLEMS

2.CHECK WIRE HARNESS (POWER STEERING ECU - BATTERY AND BODY GROUND)
a.
C366252E01
2.167,0.75 2.583,1 0.417,0.25 1.531,2.531 2.479,2.302 false 1.917,2.896 2.479,2.458 false 2.229,0.792 2.688,0.99 0.458,0.198 10 false A21 0.188,0.146 1.531,0.458 1.344,0.313 10 false Wire Harness Side: 1.021,2.469 1.542,2.688 0.521,0.219 10 false 1 (PIG) 1.26,2.865 1.948,3.115 0.688,0.25 10 false 2 (PGND)

Disconnect the A21 power steering ECU connector.


b.

Measure the voltage and resistance of the wire harness side connectors.

Standard voltage:
Tester Connection Specified Condition
A21-1 (PIG) - Body ground 10 to 14 V


Standard resistance:
Tester Connection Specified Condition
A21-2 (PGND) - Body ground Below 1 Ω




OK

REPLACE POWER STEERING ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR