The power steering ECU outputs this DTC when it determines that the assist map is not written in the ECU.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1581 | Assist map not written in power steering ECU | Power steering ECU |
If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
Turn the ignition switch on (IG).
Wait for 1 second or more.
Check for DTC.
Approximately 1 second after turning the ignition switch on (IG), the assist map writing is automatically performed. After the automatic assist map writing, DTC C1581 is erased.
C1581 is not output.
NG
OK
Check for DTCs.
DTC is not output.
OK
NG