Home › Steering › POWER STEERING › POWER STEERING SYSTEM › 2013.04–2014.09
RM24M0E _55 Steering _059561 POWER STEERING _0291895 POWER STEERING SYSTEM C

POWER STEERING  POWER STEERING SYSTEM  C1521  Motor Circuit Malfunction  C1531  ECU Malfunction  C1532  ECU Malfunction  C1533  ECU Malfunction  C1534  ECU Malfunction  C1554  Power Supply Relay Failure  


DESCRIPTION

If the power steering ECU detects these DTCs, it will shut off the motor relay circuit (built into the power steering ECU) and stop power assist. However, power assist continues if DTC C1533 or C1534 is output.

DTC No. DTC Detection Condition Trouble Area
C1521 Motor overcurrent Power steering ECU
C1531 ECU internal malfunction (CPU malfunction) Power steering ECU
C1532 ECU internal malfunction (Peripheral circuit malfunction) Power steering ECU
C1533 ECU internal malfunction (Substrate temperature sensor malfunction) Power steering ECU
C1534 ECU internal malfunction (EEPROM error) Power steering ECU
C1554 Power source relay circuit malfunction Power steering ECU

CAUTION / NOTICE / HINT

NOTICE:

If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.RECONFIRM DTC

b.

Check for DTCs.

OK:

DTC is not output.




NG

REPLACE POWER STEERING ECU

OK

CHECK INTERMITTENT PROBLEMS