Home › Steering › POWER STEERING › POWER STEERING SYSTEM › 2013.04–2014.09
RM24M0E _55 Steering _059561 POWER STEERING _0291895 POWER STEERING SYSTEM C

POWER STEERING  POWER STEERING SYSTEM  C1522  Motor Circuit Malfunction  C1523  Motor Circuit Malfunction  C1524  Motor Circuit Malfunction  C1555  Motor Relay Welding Failure  


DESCRIPTION

The power steering ECU supplies the current to the power steering motor through the motor circuit.

DTC No. DTC Detection Condition Trouble Area
C1522 Short (or open) in motor circuit or abnormal voltage or current in motor circuit
·

Steering column

·

Power steering ECU


C1523 Motor current sensor malfunction
C1524 Excessively large current deviation
C1555 Motor relay circuit malfunction

WIRING DIAGRAM

C140416E32
4.719,2.854 6.094,3.094 1.375,0.24 10 false Power Steering ECU 0.458,2.521 1.885,2.958 1.427,0.438 10 false Power Steering Motor 4.729,0.76 5.021,1.052 0.292,0.292 10 false MV 4.729,1.365 4.99,1.583 0.26,0.219 10 false MU 4.719,1.948 5.031,2.177 0.313,0.229 10 false MW 4.479,0.604 4.667,0.854 0.188,0.25 10 false 1 4.479,1.219 4.708,1.448 0.229,0.229 10 false 2 4.479,1.823 4.667,2.052 0.188,0.229 10 false 3 4.708,2.667 4.865,2.865 0.156,0.198 10 false C

CAUTION / NOTICE / HINT

NOTICE:

If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (MOTOR VOLTAGE)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and press the intelligent tester main switch ON.


c.

Select the items "Motor Terminal Volt (U)", "Motor Terminal Volt (V)", "Motor Terminal Volt (W)" in the Data List and read the value displayed on the intelligent tester.

Power steering ECU
Tester Display
Item
Measurement Item/Range Normal Condition Diagnostic Note
Motor Terminal Volt (U) Motor terminal voltage (U phase):
Min.: 0 V
Max.: 46.667 V
During steering operation, Value changes within 4 to 46 V range Steering wheel is turned
Motor Terminal Volt (V) Motor terminal voltage (V phase):
Min.: 0 V
Max.: 46.667 V
During steering operation, Value changes within 4 to 46 V range Steering wheel is turned
Motor Terminal Volt (W) Motor terminal voltage (W phase):
Min.: 0 V
Max.: 46.667 V
During steering operation, Value changes within 4 to 46 V range Steering wheel is turned

Result
Result Proceed to
During steering operation, Value changes within 4 to 46 V range A
While the steering wheel is turned, voltage is not generated B



A

REPLACE POWER STEERING ECU

B

REPLACE STEERING COLUMN