The power steering ECU supplies the current to the power steering motor through the motor circuit.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1522 | Short (or open) in motor circuit or abnormal voltage or current in motor circuit | ·
Steering column ·
Power steering ECU |
| C1523 | Motor current sensor malfunction | |
| C1524 | Excessively large current deviation | |
| C1555 | Motor relay circuit malfunction |
If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and press the intelligent tester main switch ON.
Select the items "Motor Terminal Volt (U)", "Motor Terminal Volt (V)", "Motor Terminal Volt (W)" in the Data List and read the value displayed on the intelligent tester.
| Tester Display
Item |
Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Motor Terminal Volt (U) | Motor terminal voltage (U phase):
Min.: 0 V Max.: 46.667 V |
During steering operation, Value changes within 4 to 46 V range | Steering wheel is turned |
| Motor Terminal Volt (V) | Motor terminal voltage (V phase):
Min.: 0 V Max.: 46.667 V |
During steering operation, Value changes within 4 to 46 V range | Steering wheel is turned |
| Motor Terminal Volt (W) | Motor terminal voltage (W phase):
Min.: 0 V Max.: 46.667 V |
During steering operation, Value changes within 4 to 46 V range | Steering wheel is turned |
| Result | Proceed to |
|---|---|
| During steering operation, Value changes within 4 to 46 V range | A |
| While the steering wheel is turned, voltage is not generated | B |
A
B