The motor rotation angle sensor detects the motor rotation angle and sends this information to the power steering ECU.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1528 | Motor rotation angle sensor malfunction | ·
Steering column ·
Power steering ECU |
If the steering column or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (see page Steering>POWER STEERING>POWER STEERING SYSTEM>CALIBRATION).
Check the installation condition of the motor rotation angle sensor connector.
Motor rotation angle sensor connector is securely connected to the power steering ECU.
NG
OK
Securely connect the motor rotation angle sensor connector.
Check for DTCs.
DTC is not output.
NG
OK
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and press the intelligent tester main switch ON.
Select the items "Motor Rotation Angle" in the Data List and read the value displayed on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Motor Rotation Angle | Motor Rotation Angle:
Min.: 0° Max.: 360° |
During steering operation, motor rotation angle value changes from 0 to 360° | Power steering in operation |
During steering operation, motor rotation angle value changes from 0 to 360°.
OK
NG